I was able to set up the encoder, but I was not able to install your firmware onto the VESC.
I have the same issue as RoZ "The selected file name seems to be invalid."
Also, I could not get the VESC to stop whistling in Current control mode.
Any help would be appreciated.
Hi,
Hoping to use VESC with a hoverboard hub motor. I have the motor running on stock VESC using hall sensors. I have an encoder hooked up, but it does not have an index signal.
Do I need ABZ encoder with index for this to work? Wiring diagram does not show index connected to VESC, only to Disco board. Is that a mistake in the wiring diagram?
Tanks
