Olivier, tu peux déplacer dans un nouveau topic "RRRE et DD / MMOS 2014" !
tout d'abord merci à Ipod ! 
bon je progresse et je vais donc poster sur le fofo de S3 histoire de les aider un peu
j'ai repris les réglages d'Ipod (mmos + ffb) et grace à l'ensemble de ses paramètres, le jeu fonctionne et ne plante plus chez moi en 64 bits. Après quelques tests et vérifications, voici mes conclusions :
1) lorsque je repasse avec mes anciens paramètres dans mmos, ca continue de fonctionner, donc ce ne sont pas les valeurs dans MMOS qui font planter le jeu en 64 bits
2) lorsque que je reprends mon vieux profil matériel dans RRRE, ca plante. Donc ce sont uniquement sur les valeurs ffb ci-dessous du controleur qu'il faut chercher.
Afficher le Spoiler
dans le .rcs
FFB Device Name="none"
FFB Device Name Alternative="none"
FFB Rumble Pad="0" // Type of FFB controller: 0=wheel, joystick etc with force feedback, 1 = pad with rumble motor
FFB Gain="0.47" // Strength of Force Feedback effects. Range 0.0 to 1.0.
FFB Min Force="0.0" // Minumum force, from 0.0 to 1.0
FFB Min Force Linear Percentage="0.01" // Minumum force linear percentage
FFB Throttle FX on steer axis="1" // 0 = Throttle effects on throttle axis, 1 = throttle effects on steering axis.
FFB Brake FX on steer axis="1" // 0 = Brake effects on brake axis, 1 = brake effects on steering axis.
FFB stationary friction="0.7" // Amount of friction applied to the steering wheel when vehicle is stationary
FFB stationary friction speed="2.7780001" // Below this speed the stationary friction starts to be applied, in m/s
FFB steer vibe freq mult="1.0" // Controls frequency of steering vibration. Recommended: 0.5 to 1.0, 0.0 disables steering vibration.
FFB steer vibe zero magnitude="0.0" // Magnitude of steering vibration at 0mph (reference point).
FFB steer vibe slope="0.0" // Slope of line defining magnitude as a function of frequency (used with FFB steer vibe zero magnitude).
FFB steer vibe wave type="0" // Type of wave to use for vibe: 0=Sine, 1=Square, 2=Triangle, 3=Sawtooth up, 4=Sawtooth down.
FFB steer force average weight="1.0" // How much weight is given to new steering force calculations each frame (0.01 - 1.0). Lower values will smooth out the steering force, but will also add latency.
FFB steer force exponent="1.0" // Steering force output "sensitivity". Range 0.0 to infinity. 0.0 to 1.0 = higher sensitivity, greater than 1.0 = lower sensitivity.
FFB steer force input max="11500.0" // Recommended: 11500 (-11500 if controller pulls in the wrong direction).
FFB steer force output max="0.45" // Maximum force output of steering force, recommendation 0.8 to 2.0
FFB steer force grip weight="1.0" // Range 0.0 to 1.0, recommended: 0.4 to 0.9. How much weight is given to tire grip when calculating steering force.
FFB steer force front grip exponent="0.9" // Range 0.0 to infinity, recommended: around 1.0. Exponent applied to grip weight.
FFB steer force rear grip exponent="1.0" // Range 0.0 to infinity, recommended: around 1.0. Exponent applied to rear grip loss weight.
FFB steer damper coefficient="0.2" // Coefficient to use for steering damper. Range: -1.0 to 1.0
FFB steer damper saturation="0.0" // Saturation value to use for steering damper. Range: 0 - 1.0
FFB steer force balance mode="0" // Mode for how to add the steering forces together (lateral, load and diff). Acceptable values: 0 = lat + load + diff, 1 = sqrt(lat^2 + load^2 + diff^2), 2 = sqrt(lat^2 + load^2) + diff, 3 = sqrt(lat^2 + (load + diff)^2), 4 = sqrt((lat + load)^2 + diff^2)
FFB steer load multiplier="1.85" // Multiplier for vertical load on front tires. Range: 0 - infinity
FFB steer lateral multiplier="1.0" // Multiplier for lateral forces. Range: 0 - infinity
FFB steer rack factor="0.15" // How much of the lateral forces comes from steering rack. Range: 0 - 1.0
FFB steer load change exponent="0.87" // Exponent for the change in load on front tires. Range: 0 - infinity
FFB steer load change breakpoint="1.0" // Breakpoint (value that will not be changed) for the exponent on the change in load on front tires. Range: 0 - infinity
FFB steer spring coefficient="0.1" // Coefficient for steering spring. Range: 0.0 - 1.0
FFB throttle vibe freq mult="1.0" // Scales actual engine frequency to force FFB vibration frequency. Suggested range: 0.10 to 0.50
FFB throttle vibe zero magnitude="0.0" // Magnitude of engine vibration at 0rpm (reference point).
FFB throttle vibe slope="0.0" // Slope of line defining magnitude as a function of frequency (used with FFB throttle vibe zero magnitude).
FFB throttle vibe wave type="0" // Type of wave to use for vibe: 0=Sine, 1=Square, 2=Triangle, 3=Sawtooth up, 4=Sawtooth down.
FFB rumble strip magnitude="0.3" // How strong the rumble strip rumble is. Range 0.0 to 1.0, 0.0 disables effect.
FFB rumble strip freq mult="2.0" // Rumble stip frequency multiplier 1.0 = one rumble per wheel rev.
FFB rumble strip wave type="0" // Type of wave to use for vibe: 0=Sine, 1=Square, 2=Triangle, 3=Sawtooth up, 4=Sawtooth down.
FFB rumble strip pull factor="0.2" // How strongly wheel pulls right/left when running over a rumble strip. Suggested range: -1.5 to 1.5.
FFB jolt magnitude="1.0" // How strong jolts from other cars (or walls) are. Suggested Range: -2.0 to 2.0.
FFB shift jolt magnitude="0.4" // How strong jolts you get from shifting. Suggested Range: -2.0 to 2.0.
FFB shift effect duration="0.05" // Duration of shift effect in seconds
FFB slip effect="0.9" // Slip effect, from 0.0 to 1.0
ffb slip freq multiplier="1.0" // Slip effect frequency. 1.0f = 1 cycle per wheel rev
ffb slip wave type="0" // Slip effect wave type
Je vais tacher de comparer une à une les lignes d'Ipod et les miennes et voir sur laquelle / lesquelles ça merde
Bon je confirme : les 2 valeurs à 0, le jeu ne plante plus en 64 bits
